There is a lot of dust in the workshop, troubled by dust severely, the company for better production in the workshop, always use the dust collector for cleaning the dust. How to deal with the dust removal in the grinding workshop.
Using fans can quickly blow out the dust, but it can’t meet the national dust emission standards, therefore, it is required to use fume extractor to treat the exhaust gas of the dust removal in the grinding workshop. For the part where the dust source is generated, the closed dust removal method is often used to prevent the spread of the dust source, slow down the rate of workshop pollution, and just need regular cleaning.
Dust collectors usually use highly automated settings for easy management, when we purchasing, we must pay attention to the level of the key technical personnel of the manufacturer, don’t be sloppy, otherwise the performance of the dust collector will be affected.
High-level manufacturers can take a combine production for equipment and can meet the various needs of the workshop, when the area required for the equipment is small, and the use of bag dust collectors need a large area, we can use the dust removal method of cyclone and bag at this time. Use the cyclone body instead of the settling chamber to reduce the volume of the equipment.
Combined dust collector equipment has relatively high technical requirements, the exhaust gas is required to be able to reach the expected treatment state in each link, in order to make the air finally discharged into the atmosphere meet the standard. Use active carbon to absorb when clean the dust with a strong odor, use water film to remove dust for dust with strong adhesion, use desulfurization towers to treatment for sulfur and other chemical elements, use correct operation of dust removal in grinding workshop.
Air Purifying Tower
Combined Dust Collec...
Central Fume Extract...
